Maxon UM-SL55 User Manual download pdf (Page 11)

CHARGING THE BATTERY

When your battery reaches low capacity, you should

recharge the battery or replace with a charged battery as

soon as possible. In this condition, use of the transmitter

should be avoided as this quickly drains the battery.

The rechargeable battery packs may be recharged

separately or while still attached to the radio.

To use the trickle charger supplied with the radio, turn off the

radio and insert the charging adapter into the lower socket of

the accessories connector . The battery should be fully

charged in 1012 hours. Using the Maxon fast charger,

batteries may be charged in under 2 hours.

DIAGNOSTIC MESSAGES

In addition to the low battery condition, a flashing red status

LED may also indicate fault conditions.

Should your radio apparently not operate correctly, replace

the battery with one known to be fully charged. If the

condition persists, or the radio emits an unexpected

continuous pattern of audio beeps, or will not transmit or

receive as it does normally, return the radio to your Maxon

dealer.

Unprogrammed channel

If your radio has been set-up for less than the maximum

number of channels, turning to a blank channel will cause

your radio to beep and the status LED will flash red,

indicating that the channel is unusable.

Receive only channel

Your radio may be set-up to receive on a channel but not to

transmit. If PTT or call functions are started on such a

channel, the radio will beep and the LED will flash red.

ENGLISH

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 62 63

No comments

Maxon UM-SL55 User Manual Page 11